This 4-1/2" vacuum cup with an aluminum tripod adapter lets you mount your GoPro on your car, boat, or any non-porous surface. The pump-action vacuum creates 120 pounds of pull strength without damaging the surface it's attached to.
Features:
Specs:
This 4-1/2" vacuum cup with aluminum tripod adapter lets you mount your GoPro action camera to most horizontal or vertical, non-porous surfaces without drilling any holes. It's perfect for your car, boat, or any other vehicle. It uses a pump-action vacuum to create 120 pounds of pull strength without damaging the surface it's attached to.
You can mount the vacuum cup horizontally or vertically without risk of it becoming detached during travel. Simply screw your Go-Pro's tripod into the adapter and you're ready to capture your shot.
This vacuum cup holder is quick and easy to mount. To install the vacuum cup make sure the mounting surface is clean and place the cup on your vehicle then press the pump several times until the orange band disappears. To break the seal and remove the holder from your vehicle or wall simply pull the T-shaped tab up and towards the center of the cup. As suction decreases over time the plunger will extend from the cup. When the orange indicator band shows simply re-pump the plunger.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at the SeaSucker for GoPro action cameras. This mount is great and ideal for attaching your GoPro action camera. It's a very sturdy mount. The GoPro adapter, that's this component right here, it's made from a strong and rust-proof aluminum construction. The unit's gonna feature a 4-1/2 inch vacuum seal that has a pull rating of 120 pounds. It can be attached in many different surfaces, anything that's rigid and nonporous.
It does come with a protective cap, goes over the seal to keep it safe and protected when the mount's not being used. The product is black in color. It's made in the USA. It also comes with waterproof lubricant to keep the SeaSucker components working as they should. The mount when fully installed's going to be about three inches tall, and it's gonna have a diameter of around 4-7/8 of an inch when installed. Installation is quick and easy.
Of course, you would attach your GoPro action camera directly to the mount right here, and then you want to make sure that the vacuum mount is clean and that the mounting surface is clean. Place it on the mounting surface and start pumping this plunger. As you do that, it's taking the air that's underneath this seal and removing it, which is creating this nice, tight vacuum seal that we're looking for. So you keep pushing that until this orange portion stays hidden inside the housing. Once that stays hidden, you're gonna know that the unit is fully seated and installed and ready for use. Now when you're ready to remove it, you'll need to lift up on these tabs. That's gonna break the vacuum seal, allowing the unit to easily be removed.
That's gonna do it for today's look at the SeaSucker for GoPro action cameras.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.